SENA Parani10 - Manual (Page 40)

40
Description : Once paired, your PARANI10 uses the stored link key. By using this AT
command, you can make Bluetooth connection with a new link key. When n is
set to 1, your PARANI10 newly generates a link key during connection
process.
AT+UARTCONFIG, baudrate, parity, stopbit,handshaking
Function : Configure the serial port of your PARANI10.
Response : OK
Description : By using this AT command, you can reconfigure the serial port of your
PARANI10. You can set baudrate, parity, stopbit . To make this command
result active, you should do soft-reset or turn off/on your PARANI10. The
following values are permitted for each parameter.
•
Baudrate = 1200, 2400, 9600, 19200, 38400, 57600 or 115200.
230400 (only for Parani10)
•
Parity = N (No parity), E (Even parity) or O (Odd parity).
•
Stopbit = 1 or 2.
•
Handshaking = 1 or 0
(If ‘1’, hardware handshaking will be used. If ‘0’, handshaking function of
Parani10 will be turned off)
Full AT commands set
No. Command Response Comments
1) AT OK
2)
ATZ OK Drops all connections, disable Inquiry
and Page scans. Reset the Bluetooth
module.
3) AT&F OK Reset to factory default state
4)
AT+BTINQ? 112233445
5,FriendlyName,Co
D
112233445
5,FriendlyName,Co
D
112233445
5,FriendlyName,Co
Inquiry nearby devices. The OK at
the end means end of inquiry.