beautypg.com

6 at command vs. operational status – SENA Parani10 User Manual

Page 25

background image

25

their counterpart in their internal Flash.

When desired, release the

connection as directed in section 3.2.4.

4. Set the operating mode of one Parani10 to MODE 1 by entering an ‘AT+

BTMODE’command as shown below.

5. Set the operating mode of the other Parani10 to MODE 2 by entering an

‘AT+BTMODE’command as show below.

6. Turn both Parani10 units power off.

The Parani10 pair will connect

automatically when they are powered up again.

7. To release this paring, set them to MODE 0 by entering ‘AT+BTMODE, 0’. or

reset the units by pressing the RESET button.

3.2.6 AT command vs. Operational Status

The AT command sets listed above can be executed per Parani10 operational status.

The

AT+BTMODE,0

OK

AT+BTCANCEL

OK

AT+BTMODE,2

OK

AT+BTMODE,1

OK

See also other documents in the category SENA Computer Accessories: