Ato Page 37: At+btlast?
Page 37: At+btlast?
37
PARANI10 goes into STANBY STATUS. Once PARANI10 enters into
STANDBY STATUS, you can use any AT command sets supported by
PARANI10.
ATO
Function :
Make transition from STANBY STATUS to ONLINE STATUS.
Response :
None
Description :
This AT command is the counter operation of ‘+++”. You can change the
operating status to ONLINE STATUS again by using this command. In
ONLINE STATUS, the data can be transferred between two hosts. The
existence of your PARANI10 becomes transparent to any host applications
which use serial ports.
ATH
Function :
Release the current Bluetooth connection.
Response :
Description :
This AT command can be used for disconnecting the existing Bluetooth
connection.
AT+BTSEC, Authentication, Encryption
Function :
Set Bluetooth authentication or encryption features selectively.
Response :
Description :
By using this AT command, you can set authentication or encryption feature of
your PARANI10 during Bluetooth connection process. Once you set
authentication or encryption features, your PARANI10 stores its status. To
release authentication or encryption features you set, you should use this AT
commands or do soft-reset. To enable authentication or encryption, set
authentication or encryption parameter as 1. Otherwise set either of them as 0.
AT+BTLAST?
Function :
Return BD_ADDR of the Bluetooth device to your host which your PARANI10
is connected most recently.
Response :
Description :
You can use this AT command if you need to refer the BD_ADDR of most