SENA Parani10 User Manual
Page 43
43
23)
AT+BTCSD
Clear the list of secured devices
24)
AT+BTFP,n
Force paring when connecting as
master
25)
AT+UARTCONFIG,baudrate,parity,st
opbit,handshaking
Sets
the
configuration
of
UART
interface. Possible values are;
baud rate
=1200,4800,9600,19200,38400,5760
0 or 115200.
parity =
(No parity), (Even parity) or
(Odd parity).
stop = 1 or 2.
Handshaking = 1 or 0
(If ‘1’, hardware handshaking will be
used. If ‘0’, handshaking function of
Parani10 will be turned off)
26)
AT+SETESC,nn
Sets the escape sequence character.
‘nn’should be ASCII code (Decimal),
and
printable
character.
Default
escape character is ‘+++’
27)
AT+PINQ?
For Periodic Inquiry. Parani10 will try
to inquire nearby Bluetooth devices
periodically and deliver the inquired
result to Host. To lease periodic
inquiry function, AT+BTCANCEL.
28)
AT&V
Shows S-register values
S-register command: If you change the values of S-register, please reboot Parani10.
ATSnn=mm
ATSnn?: To check current ATSnn register value.
29)
ATS3
Stream UART policy (Default 0)
If set as ‘0’, throughput is the priority, if set as ‘1’, Latency
is the priority.
30)
ATS4
Enable Remote name query (default 1)
Get BDaddress and device name during Inquiry.
If set as ‘0’, only get BD address. Inquiry time can be