Ocean Optics LIBS2500plus - Manual (Page 31)

3: Operation
166-00000-000-02-0110 21
Option Description
Integration Start Delay Displays the current position of the Integration Start Delay slider bar.
Cumulative Q-Switch
Delay Displays the entire delay time representing the Q-Switch Delay.
Slider Bar Increases or decreases the Integration Start Delay in .41667 µs intervals.
► Procedure
1. Enter a Laser 1 Delay setting taking into consideration Big Sky Laser’s recommended setting.
2. Enter a Laser 2 Delay setting taking into account the desired delta between the two pulses and
that this laser also requires time to build power.
3. Click the Set button.
Note:
Since these values are initialized to the last saved settings, you will only need to perform
the following steps if the requirements of the experiment require a change of these
settings.
4. Move the slider bar to desired Integration Start Delay value. Refer to the displayed spectrum to
determine if any further modification is needed.
5. Click OK to accept these settings or Cancel to return to the main screen.
Setup Options
Use this screen to configure the setup options for your LIBS system.