Buyers 5412001 - Manual (Page 2)

2
3. Position assembled van partition into place and
secure. Make sure the van partition is plumb and
perpendicular to the ribs in van floor or roof. Mark
all hole locations and make any needed bracket
adjustments at this time. Mark all holes for roof,
floor, driver-side ribs, and passenger door. Remove
van partition and drill needed holes. Attach
assembled van partition and tighten securely (fig. 3).
Fig. 3
3024850 Rev. A
WArrAnTy
Buyers Products Co. warrants all truck/trailer hardware manufactured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment. Parts must be properly installed and used under normal conditions.
Any product which has been altered, including modification, misuse, accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of Buyers Products Co. under this warranty is limited to repairing or replacing any part
or parts which are returned, prepaid, and are found to be defective by Buyers Products Co. Authorization from Buyers Products Co. must be obtained
before returning any part. No charges for transportation or labor performed on Buyers’ products will be allowed under this warranty.
Bill of Material
ITEM PART NO. QTY. DESCRIPTION
1 301863 1 Bulkhead, Weldment
2 3018422 2 Strap, Roof Brace
3 3018423 2 Strap, Side Wall
4 3018653 2 Anchor, 1/4-20 Thread
5 3008222 2 Screw, HWH 1/4-14 x 1, Self Drill/Tap, ZN
6 – 6 Screw, Cap 1/4-20 x 3/4 Gr. 5, ZN
7 – 4 Nut, Nylon Insert 1/4-20 ZN
8 – 12 Washer, Flat 1/4 SAE, Clear ZN