Buyers SMR50P - Manual

Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
Installation Instructions
SMr50P
Side Mount Polymer Reservoir
Bill of Materials
1 3002290 1 Reservoir
2 3002284 2 Bracket
3 3002442 2 Strap
4 TC0015 1 Cap
5 HD200125 1 Diffuser
6 RAB200125 1 Reducer, 2" NPT x 1.25" NPT
7 FWF038100007 4 Washer Flat 3/8" dia.
8 FNE038016044 4 Nut, Hex 3/8-16 Nylock
9 3001384 8 Screw Hex, 1/2-13x2
10 FWF050106010 8 Washer, Flat 1/2"
11 FNE050013053 8 Nut, Hex 1/2-13 Nylock
12 3002631 2 Label, “No Step”
item part no. qty. description
—continued on back
Procedure
1. Find appropriate area on frame rail for mount-
ing. Tank length is 30".
2. Using mounting dimensions for bracket or first
bracket as pattern, locate and mark holes for drill-
ing. Tops of brackets should be flush with top of
frame. Drill holes.
3. Mount brackets to frame using 1/2" bolts,
washers, and nuts
4. Clean tank surface on brackets. Set tank onto
brackets.
5. Place straps’ T-bolts into appropriate holes in
brackets. Install 3/8" washers and nuts and tighten
them. Tighten until straps are snug on front and
top surfaces of tank. Do not over tight. Clean
desired areas on straps and place “no step” labels.
6. Install reducer and return line diffuser into work
ports. A thread sealant recommended (do not use
teflon tape). Reducer and diffuser can be fitted into
either port for easy installation but must be prop-
erly hooked up to the pump.