Buyers LT35 - Manual

Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
Installation Instructions
LT35 Hand Tool Rack
for Utility Landscape Trailers
—continued on other side
1 3004207 1 Post, Hand Tool Rack
2 3004165 2 Angle, Tool Holder
3 3004167 12 Grommet, Rubber, for 2" hole
4 - 4 Screw, HHC 5/16-18 x 1-1/2 Gr 5 Zn
5 - 4 Nut, Nylock 5/16-18 Zn
6 - 6 Washer, Flat 3/8 USS Zn
7 - 1 Screw, HHC 3/8-16 x 2 Gr 5 Zp
8 - 2 Screw, HHC 3/8-16 x 2-1/2 Gr 5 Zp
9 - 3 Nut, Nylock 3/8-16 x 7/16 Zn
10 - 1 Plug, Plastic Finish, 1" Square Tube
ITEM PART NO. QTY. DESCRIPTION
Bill of Materials
Important!
Before you begin installing:
1. Read and understand these instructions
completely.
2. Verify that you have received all the parts
listed in the bill of materials.
Tools Required:
•Two 9/16" wrenches and/or sockets
•Two 1/2" wrenches and/or sockets
•Electric drill
•13/32” Drill bit
•Carpenter’s square
•C-clamp
CAUTION:
Always wear safety glasses when using power tools.
1. Clamp the post of the hand tool rack to the
trailer side rail. The hand tool rack uses 4" x 23"
of the trailer floor space and the post is centered
in this space.
Position the hand tool rack such
that the lawn mowers or other equipment will
not damage the hand tool handles. Verify that
the post is square to the trailer deck in both direc-
tions with a carpenter’s square.
2. After determining the position of the post
mark center of the two holes in each upright base
on the trailer deck.
WARNING! Check under the trailer for locations
of brake lines and electrical wiring etc., before
drilling any holes. Any damage to trailer during
installation is installer’s full responsibility.
3. Remove the post from the trailer and use a
13/32" drill bit to drill two holes in your trailer
floor as marked.