Buyers 5051105 User Manual
Liftdogg, Installation manual, Truckmount

1
1. Secure the mounting extension to the Mounting holes of
the liftgate using eight 3/8" bolts, eight washers, and eight
locknuts. (fig. 1)
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
—continued inside
installation
manual
MOUNT KIT
5051105
GM
1500/2500/3500
2007+
full
size
truck
LiftDogg
™
3. Tail light Remounting. This step must be done prior to
install the Liftgate so lens can be replaced without removing
the Liftgate. (fig. 2)
a. Remove four factory tail light screws on both sides.
b. Remove the tail light lens.
c. Remove any tailgate accessories that haven’t done
previously.
d. Install the tail light lens without factory fasteners.
e. Install the M8 x 1.25 x 12 bolts and tail light clips
provided. This is mounted at the tailgate cable catch
bolt. Push the clip forward to have a rigid support when
tightening the screw.
truckmount
Fig. 1
2. On the truck, remove the tailgate and tailgate hardware.
Tailgate will not be reused.
a. Remove the striker when the tail light is loosened later.
b. Remove the rear bumper. Be careful not to drop the
bumper when unfastened the bolts/nuts.
c. Remove the spare tire access plug (truck’s key is needed).
d. Remove the spare tire temporarily.
e. Remove the hitch for now.
Tail Light Bolt
Tail Light Bolt
Striker
Apply Pressure When
Install Light Bracket
Fig. 2
Secure the 8 Bolts to the Liftgate
Mounting Extension
Bottom Holes not Used