Factory Direct Hardware Von Duprin 9957EO26D3 - Manual (Page 49)

47 47 47 47
Power Supplies
PS861 Power Supply
Standard
UL Listed
Class 2, Power Supply
UL1012
UL1310
The series PS861 power supply is designed for electric locking or
monitoring on single or double door applications. The output power is
field selectable for either 24 VDC @ 1 ampere or 12 VDC @ 2 ampere.
Standard input 120 VAC @ 0.6 ampere and 240 VAC @ 3.0 ampere
available. The terminal block will accept up to 14 gauge stranded wire.
The gray enclosure is 10" x 10" x 4" (254mm x 254mm x 102mm), has a
hinged cover, and is constructed of heavy 19 gauge steel. Six
¹ ₂" (13mm)
knockout holes are provided for conduit connection.
Options include keylock cover or Battery Backup. The pair of batteries,
which are sealed lead acid battery packs, will provide back-up power for
three hours at full load or seven hours at half load. Batteries will automati-
cally recharge when failed power is restored.
Four Models:
PS861 Standard supply
PS861K Standard supply
with keylock cover
PS861B Battery backup
PS861FA Fire Alarm
PS861BK Battery backup and
keylock cover
PS861BKFA Battery backup and
keylock cover with
FA board (24VDC only)
PS9 Power Supply
The PS9 is an AC power supply that provides 9 VDC power to operate
the ALK alarm kit. The unit will power one or two alarm kits. Included is
a 9-volt sealed battery that provides backup power in case of an AC
power failure.
Electrical Power Transfer –– EPT
Pneumatic Transfer – PNT
Electric Power Transfer provides a means of transferring electrical power
from a door frame to the edge of a swinging door. The units are
completely concealed when the door is in the closed position, and are
ideally suite for installations involving abuse or heavy traffic.
Two models are available; EPT-2, two 18 gauge wires and EPT-10,
ten 24 gauge wires. The EPT-2 and EPT-10 are U/L listed as
“miscellaneous door accessory”.
Pneumatic Controls
PNT-1 is available for pneumatic latch retraction exit devices.
Appearance and dimensions are identical to EPT models.
UL Listed for use on firedoors
Door applications:
up to 5" butt hinges – 180˚ swing,
5
¹ ₂" butt hinges – 130˚ swing,
6" butt hinges – 110˚ swing,
³₄" butt offset pivots 180˚ swing.
Not for use with swing clear hinges or center-hung pivots.
Finishes
SP28 (sprayed aluminum)
SP313 (sprayed duranodic).
Dimensions
Housing 9" x 1 ¹ ₄" x 1 ⁵ ₈" (229mm x 32mm x 38mm)
EPT-2 Two 18 gauge wires,
Up to 2 AMPS @ 24VDC,
with a 16 AMPS Maximum Surge
EPT-10 Ten 24 gauge wires, Up to 1 AMPS @ 24VDC, with a
16 AMPS Maximum Surge
PNT-1 ⁵₃₂" Tubing
To order, specify:
1. EPT-2 ,EPT-10 or PNT-1.
2. Finish, SP28 or SP313.
98/99™ Electrical Accessories
Electrical Accessories