Vonnic C909IP H.264 Wireless 802.11b_g_n IP Network Camera - Manual (Page 9)

H Series IP Camera User Manual – with Pan/Tilt of CMOS
9
2) The PC and IP Camera are in different LANs, but they are all connected to Internet. For
the IP Camera-1 and PC-2 in Figure 5, if you want to visit IP Camera-1 by PC-2, you
should firstly do the setting as 1) to make sure that you can visit IP Camera-1 through
PC-1 and then do the setting of router-1 (do the port forwarding from the router). The
PC- 2’s visit application could be sent through router-1 to IP Camera-1. Normally, PC-2
could only send the information to router- 1, if you don’t do the setting of router-1, then
PC-2 could not visit IP Camera-1.
5 Visit IP Camera from LAN
5.1 Set IP Address
The IP addresses of IP Camera and PC should be at the same segment, in Figure 5, the IP
Camera-1 can’t be visited. Run the HSearch_en.exe in the CD, click Search button, and then
select the IP Camera to reset the IP Camera’s IP address, as the Figure 6.
Figure 6
If you have the firewall software in your PC, when you run the HSearch_en.exe, it
may pop up a window to say if you want to block this program or not, then you
should choose not to block.