Powersolve 600S Seires - Manual

Unit 8A
Arnhem Road
Newbury. RG14 5RU Tel: +44 (0) 1635 521858
Fax: +44 (0) 1635 523771
www.powersolve.co.uk
600 S - Se ries 600 W
SWITCHED MODE DC POWER SUP PLY
Fea tures :
• Very high re li abil ity, MTBF 1.000.000 hrs • No RFI prob lems, RFI fil ters in out put and in put
• Natural convection cooling • Meets EN 61000-3-2 and V DE 0160 class 2
• Thermally over-rated for high ambient temperature without derating • Low inrush current
• Build-in diode for redundant parallel operating • High efficiency 89%
• Under-voltage alarm contact • Short circuit protected
• Low output ripple, 7 mV rms • Analog programmable
Spec i fi ca tions :
• I nput voltage : AC 198-264 V 48-62 Hz 3.8 Arms • Line distortion : Harmonic current meets EN 61000-3-2
fuse 6.3 A T, crest factor 2.0 • Safety : EN 60950, EN 61010 SELV / PELV
: AC 99-132 V 48-62 Hz 7.6 Arms • Output voltage : Screwdriver adjustable with 10-turn
fuse 12.5 A T potmeter at the rear side.
: DC contact factory Factory set at 24.0 V
• Insulation Also analog programable by 2-5 V
• Input / output : 3750 V rms (1min) • Efficiency : 89% at 230 V AC input and 600 W output
• Input / case : 2500 V rms (1min) (max. heat dissipation 74 W)
• Output / case : 500 V DC • Temp. coeff : 5.10-5 per °C
• Stability : 3.10-4 during, 8 hrs under constant
conditions, after 1 hr warmup.
• Inrush current : Limited by 47 Ohm (shorted after startup) • Regulation
Load 0 - 100% : Better than 10 mV
• Power factor : 0.76 at 230 V AC input and full load. line 198-264 V : Better than 5 mV
• Ripple + noise : Max 7 mV rms, 20 mV pp (BW = 20 MHz)
• EMC : EN 61204-3 Power Supply Standard • Output imp. : Less than 0.05 Ohm up to 100 kHz
: EN 61000-6-3 Emission (EN 55022B) • Recovery time : 0.3 milliseconds to recover to within
: EN 61000-6-2 Immunity 100 mV after a 50 to 100% load step
Max. deviation 300 mV
• VDE0160 impulse test : Input with stands non periodic impulse • Hold-up time : 30 ms at 155 or 230 V AC input and full
2.3 Ûn 1.3 ms of VDE0160 class 2 load. 60 ms at half load.
• Series operations : up to 500 V total voltage
• Parallel oper.
: No restrictions
• Redundant parallel : Use R+ connection via build-in Schottky
operation diode to separate the outputs. Do not use
remote sensing.
600 S 24 12 -15 V 30 A
24 V 25 A
30 V 20 A
Mod els Volt age range Cur rent range
600 S 24 12 -15 V 30 A
24 V 25 A
30 V 20 A