Industrial power supplies – Powersolve PDR Series User Manual
Page 3

INDUSTRIAL POWER SUPPLIES
Powersolve Electronics Ltd. 8A Arnhem Road, Newbury, RG14 5RU. England
Tel: 01635 521858 Fax: 01635 523771 Email: [email protected]
www.powersolve.co.uk
1.Output Voltage Indicator
(Signal)
If output Voltage ±15% will send
out a warning
(Flashing)
2. Output Current Indicator
(Signal)
3. Peak Current Indicator
(Signal)
4. Inner Temperature
(Signal)
, if
over or under the designated
operating temperature a
warning will be sent
(Flashing)
5. Running hours
(Signal)
, if
operation over 999 days the
Red LED will be flashing
6. Accumalitive running hours
from the factory
(Signal)
, if
running over 2 years the Red
LED will be flashing
1. Dual LED, when
Green LED
is on it shows the output voltage.
If the
Red LED
is flashing it means the voltage is more than
±15% of V out. It will show the output voltage and send a
warning signal via Ready Relay which will change from COM
to C2 (output OK) to COM to C1 (fault)
2. Single LED,
Green LED
on shows the output current. When
LED flashing means the output current is over the rating and
will signal a warning (Rdy Signal) as in 1. above
3. Single LED,
Green LED
on shows the peak current which is
approximately over 50mSec. To reset the peak output current
press the two arrows simultaneously and hold for more than
one second to reset to zero. After release it will measure
again over 50mSec period and do this continuosly.
4. Dual LED,
Green LED
on indicates degrees C and press ►
Red LED
on to indicate degrees F, this shows internal
temperature. When
Red LED
is flashing this indicates that
the temperature is under -20ºC/-4ºF or over +70ºC/+158ºF
and this will signal a warning (Rdy Signal) as in 1. above
Instructions for Intelligent Memory Function
5. Dual LED,
Green LED
on indicates the accumulated running
time from switch on in days or press ►
Red LED
on to
show the running time in years. If this is over 999 days or
2.73 years
Red LED
will flash and indicate a signal warning
(Rdy Signal). Pressing◄ and ►simultaneously for 3 seconds
or powering off will reset the timer.
6. Dual LED,
Green LED
on indicates the accumulated running
time since leaving the factory measured in days, or press ►
Red LED
on to indicate time in hours. This period is recorded
regardless of powering on and off. Once the total accumulated
running time is over 730 days or 2 years the
Red LED
will flash
and indicate a signal warning (Rdy Signal). This can be reset
by pressing ◄ and ► simultaneously for 3 seconds or powering
off will reset the timer