Peerless-AV WL-SA761PU-200 - Installation - Manual (Page 9)

9 of 23 ISSUED: 08-24-12 SHEET #: 180-9036-3 10-31-12
NOTE: The Wireless Receiver Assembly and Power Module Assembly position can be interchanged based on the
display's connector panel location. Install Wireless Receiver Assembly on the side closest to the connector panel.
Loosely attach the small enclosure mounting brackets (S) on the wireless receiver assembly (M) with two 1/4-20
decorative screws (Q) and two 1/4-20 nuts (R) as shown in fi g. 4.1. NOTE: The enclosure mounting bracket can
be installed with the inside notch facing downward if additional side to side adjustment is needed. Attach the
mounting brackets (S), open end of notch facing downward, to the left display bracket with two 1/4-20 decorative
screws (Q) and two 1/4-20 nuts (R) as shown in fi g. 4.2.
Position the wireless receiver assembly approximately 1/4" from the universal adapter as shown in detail 2. Once
in position, tighten the four 1/4-20 decorative screws (Q) using 4mm allen wrench (L).
Loosely attach the enclosure mounting brackets (S) on the power module assembly (N) with two 1/4-20
decorative screws (Q) and two 1/4-20 nuts (R) as shown in fi g. 5.1. NOTE: The enclosure mounting bracket can
be installed with the inside notch facing downward if additional side-to-side adjustment is needed. Attach the
mounting brackets (S), open end of notch facing downward, to the right display bracket with two 1/4-20 decorative
screws (Q) and two 1/4-20 nuts (R) as shown in fi g. 5.2.
Position the power module assembly approximately 1/4" from the universal adapter as shown in detail 2. Once in
position, tighten the four 1/4-20 decorative screws (Q) using 4mm allen wrench (L).
4
5
Wireless Receiver Assembly and Power Module Assembly Installation
fi g. 4.1
fi g. 5.1
fi g. 5.2
fi g. 4.2
DETAIL 2
1/4"
Q
Q
Q
R
S
S
M
N
M
R
R
INSIDE NOTCH
DISPLAY BRACKET
INSIDE NOTCH
DISPLAY
BRACKET