Peerless-AV HG442-HT3-S - Installation - Manual

ISSUED: 02-28-08 SHEET #: 090-9143-2 04-28-08
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.
1 of 7
Installation and Assembly - Desktop Mount for
Sharp 32
" , 37 " & 42 " HT3 models
IMPORTANT! Read entire instruction sheet before you start installation and assembly.
Models: HG442-HT3,
HG442-HT3-S
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings con-
tained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call
Peerless customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum Load Capacity.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
WARNING
Maximum Load Capacity: 75 lb (34 kg)
Tools Needed for Assembly
• 3M rubber and vinyl #80 spray adhesive (can be purchased at www.3mestore.com/62494949258.html)
• phillips screwdriver