PowerWalker SNMP DP-522 - Manual (Page 40)

2.2.4 SNMP
This page is to set NetAgent SNMP settings so it can be used by a NMS ( Network
Management System). (Eg: SNMPView, SNMPView can be found on the
NetAgent Utility CD.)
MIB System
System Name
This section is to give a name to a NetAgent.
System Contact
This section is to give a name to the administrator.
System Location
This section is to set NetAgent location.
Access Control
Manager IP Address
This section is to set the IP address that the administrator can manage NetAgent from. It
is valid for up to 8 IP addresses. To manage NetAgent from any IP address, enter *.*.*.*
into Manager IP address.
Community
This section is to set a Community name for NMS. The community name has to be as the
same as the setting in NMS.
Permission
This section is to set authorities of administrators. Options are Read, Read/Write, and No
Access.
Description
This section is for an administrator to make notes.
Trap Notification
Receiver IP Address
This section is to set receivers IP address for receiving traps sent by NetAgent. It is valid
for up to 8 IP Addresses.
Community
This section is to set a Community name for NMS. The community name has to be as the
same as the setting in NMS.
Trap Type
This section is to select if send trap according to PPC MIB or RFC1628
Severity
This section is to set Trap receiver levels. There are three levels of Trap receiver :
•
Information: To receive all traps.
• Warning: To receive only “warning” and “severe” traps.
• Severe: To receive only “severe” traps.
( Please refer to NMS manual for Trap levels.)
Accept
This section is to set to receive a trop or not.
Description
This section is for an administrator to make notes.
Event
This section is to select events for NetAgent to send traps. Clicking on Select will open a
Select Events List. Or, Click on Test is to send test trap. Event Traps may be selected
from this list. Events list is below:
34