PowerWalker SNMP DP-522 - Manual (Page 34)

2.2.1 UPS Configuration
This page is to set the UPS configuration. Any wrong settings will cause incorrect
display values or disconnection between the UPS and NetAgent.
UPS Properties
UPS Communication Type
This section is to set up the communication interface of the UPS. (eg. Contact
Closure/Megatec/Phoenixtec/ Megatec 3 phase etc.) Please refer to the UPS manual to
set the correct communication type. Any wrong settings will cause disconnection between
the UPS and NetAgent.
Number of Batteries, Battery Full Charge Voltage (V), Battery Exhausted Charge
Voltage (V)
Please refer to the UPS manual to set the value.
Date of last battery replacement (yyyy/mm/dd)
This section is to record the date when the UPS battery was last replaced.
UPS Recorded
UPS Data Log
This section is to set how often the UPS data should be logged.
Test UPS
Test UPS for every
This section is to schedule the UPS to test once a week or once every two weeks or not
to test
Test UPS on Weekday
This section is to set the UPS to test on a particular day of a week.
Start Time of UPS Test ( hh:mm)
This section is to set the UPS to test at a specific time on the test day.
UPS Test Type
This is to select which test to perform.
Warning Threshold Value
Time out of after lost of connection
This section is to set a period of time after which NetAgent will send a disconnection
warning message. This warning message will be sent after NetAgent has lost contact with
the UPS for the time specified.
Critical Loading (%)
This section is to set the UPS critical loading. (shown as %) NetAgent will send a
warning message when the UPS is overloaded.
Critical Temperature (C)
This section is to set the UPS critical internal temperature. NetAgent will send warning
messages when the UPS overheats.
28