PowerWalker SNMP DP-522 User Manual

Page 20

n Launch Device
Click Launch Device or double click the NetAgent listed in the table to launch it.

Enter the Account (Login Name) and Password (Login Password) set earlier to
login. If you did not configure one, then just click Apply to login.

o Network Settings
Choose the NetAgent from the right of the screen, then click “Configure”, would
shows the following setting page.

IP Address:Set IP address for Netagent UPS

When use at the first time, please set IP address; subnet mask; and gateway.
After setting, enter IP address from Telnet or Browser to connect to NetAgent’s
website.

When using DHCP or BOOTTP to set up IP address, IP address, Subnet Mask
and Gateway would receive directly by the system.

Fig.8 Netility : Set IP address for NetAgent UPS

Advanced:Advanced Netagent UPS Setting

In order to ensure the secure management of UPS, Netility provides two
protecting function:

Management Protocol

Netagent UPS provides HTTP/HTTPS(WEB) and Telnet to reference any
related parameter setting for the manager. Concerning with security, the
manager could build use openly or any advance port setting methods.
Followings are the description:

1. At advanced setting, two functions were set as activated by using port number

80 and 23 for Http and Telnet. As for Https and SSH are 443 and 22.

2. Untick means not using the function.

3. When set to the other port value, full IP Address must be entered in order to