Peterson BBS-1 BodyBeat Sync - Manual (Page 27)

-27-
After the computer recognizes and installs the device automatically, open the BodyBeat Sync
USB software ( Select USB Audio Device as both the MIDI In and MIDI Out Devices in Windows XP
Only ). A “Load” button will become active. Press the “Load” button to browse to the location in which
you saved your downloaded firmware update and select the file. BodyBeat Sync firmware files will always
have the extension .BIN.
Note: Holding the ‘Sync Mode Select’ button while turning the BodyBeat Sync on using the
Start/Stop - On/Off button will display the current firmware version for 4 seconds. ( If this
function does not work, it means that you’re firmware is even older than this feature and you will
need to update your firmware )
Once you have selected the firmware file,
press the Update button to allow the software
to be transferred to the BBS-1 hardware.
When the transfer has finished the BodyBeat
Sync USB software will notify you that the
update is complete. You will need to reboot
your BBS-1 by turning it off and then back
on.
This process must be repeated for every
BodyBeat Sync in your group. A bodyBeat
Sync with older firmware will not synchro-
nize to a designated “Master” that has a
newer version of firmware.