B&B Electronics 850-10960-ACDC - Manual - Manual (Page 25)

20
Power Supply Modules
Power supply modules in all models of the iMediaChassis/3 are fixed, and not end-
user replaceable.
Fans
The iMediaChassis/3 includes temperature-triggered fans. When the temperature of
the chassis reaches 40° C, the two fans activate to cool the chassis. The fans’
operation can be tested by holding the Alarm Reset Button down for 4 to 5 seconds.
The fans will activate and then they will turn off when the button is released. If the
fans do not activate, contact IMC Networks. Fans are not end-user replaceable.
The red Alarm Reset Button also functions as a Fan Test button. To verify fan
functionality, hold the button down for several seconds, the fans should engage. The
fans will turn off when the button is released.
Installing Management and Application Modules
SNMP Management Modules include two twisted pair ports, one for management
and one reserved for future use. The Management Module also features a DB-9
serial port, and supports SNMP V1/V2c.
Installing Applications Modules
To install a module:
1. Remove the blank bracket (if present) covering the slot where the module will be
installed. IMC Networks recommends installing blank brackets in unused
module slots.
2. Slide the module into the chassis using the card guides.
3. Secure the module to the chassis by tightening the captive screw. (Refer to the
documentation shipped with the module for configuration information.)
In order to manage an iMediaChassis series, the SNMP Management Module needs
to be installed in the appropriate slot of the chassis.
• Install the iMediaChassis/3 slot SNMP Management Module into the bottom left
slot.
NOTE
This slot is ONLY for the Management Module; do not install Application Modules such as
media conversion and mode conversion modules in this slot.