B&B Electronics 7018TX - Manual - Manual (Page 115)

(Revised 8/3/2009) Page 115 of 138
CLI Commands, Continued…
Save or Reset the Configuration Settings
Command Name config
Description Save or reset configuration settings
Syntax config s[ave] | r[eset]
Parameters save
save current running configuration settings.
reset
reset configuration settings to factory defaults.
Examples N-TRON/Admin> config save
Save Settings...
Settings have been saved.
N-TRON/Admin> config reset
Resetting to factory defaults...
Load factory default settings [y/n]?y
Keep IP, subnet mask, and gateway addresses [y/n]?y
Keep current user names and passwords [y/n]?y
…
NOTES
Show or Set IGMP Configuration
Command Name igmp
Description Show or set IGMP configuration. If no parameters are specified, this command will show
the IGMP configuration (same as -show parameter).
Syntax igmp [-show] [-status state]
Parameters -show
Show configuration.
-status state
Set the IGMP status to e(nabled) or d(isabled).
Examples N-TRON/Admin> igmp –show
IGMP Status : Enabled
Query Mode : Auto
Router Mode : Auto
Manual Router Ports : (None)
N-TRON/Admin> igmp –status disabled
IGMP Status : Disabled
Query Mode : Auto
Router Mode : Auto
Manual Router Ports : (None)
Changes have been made that have not been saved.
…
NOTES