B&B Electronics RT3G-300_310_320_330_340-W - Configuration Manual - Manual (Page 58)

B&B Electronics, Inc. SPECTRE Configuration Manual
58
SPECTRE_Configuration_Manual_2912m
www.bb-elec.com
www.bb-europe.com
Note: If no phone number is filled in, the router will accept incoming messages from all
phone numbers. If any phone numbers are entered into the list, the router will only accept
SMS messages which originate from those numbers.
Control SMS messages cannot change the router configuration. Any changes made
to the router by an SMS message will only remain in effect until the router is restarted. After a
reboot, the router configuration will return to the settings in non-volatile memory. For
example, if the router is switched offline by an SMS message, the router will remain offline
until the next time it is power cycled or re-booted.
To control the router using SMS, the message text must contain the control
command. Table 48 lists the SMS control messages that are supported.
SMS Control Message Description
go online sim 1 Switch to SIM1 card
go online sim 2 Switch to SIM2 card
go online Switch router in online mode
go offline PPP connection termination
set out0=0 Set binary I/O output to 0
set out0=1 Set binary I/O output to 1
set out1=0 Set binary output on port 1 to a 0
set out1=1 Set binary output on port 1 to a 1
set profile std Set standard profile
set profile alt1 Set alternative profile 1
set profile alt2 Set alternative profile 2
set profile alt3 Set alternative profile 3
reboot Router reboot
get ip Router will send an SMS message back with the IP address from
the SIM card.
Table 47: SMS Control Commands
You may send and receive SMS messages using either the serial expansion ports or
a TCP connection over the Ethernet network. For serial communication, the baud rate must
be set to match the attached host. Select option Enable AT-SMS protocol on expansion
port 1 to allow messages to be sent and received using serial port 1.
Item Description
Baud rate Communication speed expansion port 1
Table 48: Send SMS on serial PORT1 configuration
Select option Enable AT-SMS protocol on expansion port 2 to allow messages to
be sent and received using serial port 2.
Item Description
Baud rate Communication speed expansion port 2
Table 49: Send SMS on serial PORT2 configuration
It is also possible to send and receive SMS messages over a TCP/IP connection by
choosing Enable AT-SMS protocol on TCP port. The TCP port used for sending and
receiving SMS messages must be entered into the configuration field.
Item Description
TCP Port TCP port on which will be allowed to send/receive SMS messages.
Table 50: Send SMS on Ethernet Port configuration