Rainbow Electronics MG260 - Manual (Page 75)

MG260 Product Specification
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without prior written
agreement.
3.3.2 GPS RF performances
The main parameters for receiver are:
Parameter Specification
Receiver type L1 frequency (1575.42 MHz)
C/A code
50-channels
8192 search bins
Max. Update Rate 4 Hz
Position: 2.5m CEP 2 / 5.0m SEP 3 Accuracy_
(Selective Availability off) Position DGPS or SBAS 1 : 2.0m CEP / 3.0m SEP
Fast
acquisition
mode
Normal
mode
High
sensitivity
mode
Cold start 4 29 s 36 s 41 s
Warm start 29 s
Acquisition
Hot start < 1 s
Signal Reacquisition < 1 s
Fast
acquisition
mode Normal
mode High
sensitivity
mode
Acquisition -134 dBm -138 dBm -140 dBm
Sensitivity 6
Tracking -143 dBm -146 dBm -149 dBm
Timepulse Accuracy RMS
99 %
Granularity
50 ns
<100 ns
43 ns
Dynamics ≤ 4 g
Operational Limits COCOM restrictions
1 Depends on accuracy of correction data of DGPS or SBAS service
2 CEP=Circular Error Probability: The radius of a horizontal circle, centered at the antenna’s true position, containing 50 % of the fixes.
3 SEP=Spherical Error Probability: The radius of the sphere, centered at the true position, containing 50 % of the fixes.
4 Measured with good visibility and –125 dBm signal strength
5 Demonstrated with active antenna
In Single Coax configuration:
e when the module is in idle mode (GSM or GPRS), loss is < 0.1 dB in C/N,
e when the module is in GSM TCH/FS or TCH/data mode, loss is roughly 4 dB
in C/N.
Because of high number of GSM slots allocated in packet data transmission
(GPRS), the use of single coax configuration is not recommended with GPRS.