Rainbow Electronics MG260 - Manual (Page 53)

MG260 Product Specification
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without prior written
agreement.
2.9 Electrical characteristics
2.9.1 Power Supply
2.9.1.1 Introduction
The table below sums up the power supply inputs / outputs available on the
MG260 module:
Power suply Pin # I/O Description
VBATT 75, 77,
78, 79,
80 I Main power supply for both GPS and GSM
functions
GPS_VANT 18 I GPS antenna supply
VCC 60 O 2.8 V Power supply for external
digital devices
VCC_RTC 76 I/O RTC back-up power supply
2.9.1.2 Main power supply (VBATT)
Parameter Condition Min Typ Max Unit
Maximum output power
2.0 A peak
3.4 3.8 4.2 V
VBATT voltage
Rising time 10 μs
f*
≤100 kHz 10 mVpp
100 kHz 3 mVpp
f*=400 kHz 3 mVpp
f*=600/800/1000 kHz 0.5 mVpp
f*=500/700/900 kHz 1 mVpp
f*=1100 kHz 1 mVpp
f*=1200 kHz 1 mVpp
f*=1300 kHz 2 mVpp
f*=1400/1600 kHz 1 mVpp
f*=1500/1700 kHz 3 mVpp
Ripple voltage
(U
ripp
) before RF
parameters are
damaged
At T=25 °C
And
V=3.8 V
f*=1800 kHz 3 mVpp
Drop Voltage Maximum output power / V=3.8 V 300 mV
f*=ripple frequency measured in the burst.