Rainbow Electronics MG260 - Manual (Page 49)

MG260 Product Specification
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without prior written
agreement.
Signal Pin # I/O I/O type Description
GPS_EN 21 I/O 1V8_CMOS Activation of the GPS function
2.6.10.2 Digital to Analog Converter
MG260 provides a digital to analog converter.
This output voltage level varies according to a programmable value. It can be
used as a programmable voltage generator.
Pin description
Signal Pin # I/O I/O type Description
AUXDAC 31 O Analog D/A converter
2.7 GPS interface
2.7.1 GPS activation
The GPS function can be activated/deactivated by hardware command
through the GPS_EN signal available on the system connector and acting as:
e An input when GPS activation is hardware controlled,
Hardware Activation:
Hardware activation pin for GPS function is available on the system connector
(GPS_EN):
e high logic level: enable the GPS section.
The voltage level of this signal has to be maintained between 2.4 V and
VBATT.
e low logic level: disable the GPS section.
Pin description