Rainbow Electronics AT27LV520 - Manual (Page 3)

AT27LV520
3
Note: 1. Minimum voltage is -0.6V DC which may undershoot to -2.0V for pulses of less than 20 ns. Maximum output pin voltage is
V
CC
+ 0.75V DC which may overshoot to +7.0V for pulses of less than 20 ns.
Notes: 1. X can be V
IL
or V
IH.
2. Read, output disable, and standby modes require 3.0V ≤ V
CC
≤ 3.6V, or 4.5V ≤ V
CC
≤ 5.5V.
3. Refer to Programming Characteristics.
4. V
H
= 12.0 ± 0.5V.
5. Two identifier bytes may be selected. All A8 - A15 inputs are held low (V
IL
), except A9 which is set to V
H
and A8 which is tog-
gled low (V
IL
) to select the Manufacturer’s Identification byte and high (V
IH
) to select the Device Code byte.
Absolute Maximum Ratings*
Temperature under Bias ................................ -55°C to +125°C *NOTICE: Stresses beyond those listed under “Absolute
Maximum Ratings” may cause permanent dam-
age to the device. This is a stress rating only and
functional operation of the device at these or any
other conditions beyond those indicated in the
operational sections of this specification is not
implied. Exposure to absolute maximum rating
conditions for extended periods may affect device
reliability.
Storage Temperature ..................................... -65°C to +150°C
Voltage on Any Pin with
Respect to Ground .........................................-2.0V to +7.0V
(1)
Voltage on A9 with
Respect to Ground ......................................-2.0V to +14.0V
(1)
V
PP
Supply Voltage with
Respect to Ground .......................................-2.0V to +14.0V (1)
Operating Modes
Mode/Pin ALE OE/V
PP
A8 - A15 AD0 - AD7
Read (2) V
IL
V
IL
Ai D
OUT
Output Disable (2) V
IL
/V
IH
V
IH
X (1) High Z/A0 - A7
Standby V
IH
V
IH
Ai A0 - A7
Address Latch Enable (2) V
IH
V
IH
X A0 - A7
Rapid Program (3) V
IH
V
PP
Ai D
IN
Product Identification (4) V
IL
V
IL
A9 = V
H
(5)
A8 = V
IH
or V
IL
A10 - A15 = V
IL
Identification Code