Rainbow Electronics GE863-GPS low power - Manual (Page 51)

GE863-GPS Software User Guide
1vv0300724 Rev. 3 - 05/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 51 of 122
•
wait for response:
Response Reason Action
OK Barring is now enabled/disabled all outgoing calls will be
barred/unbarred
ERROR some error occurred Enable the extended error
codes report (see par.2.5.2.1)
and retry.
+CME ERROR: 4 operation not supported, the
service required is not available Check command syntax
+CME ERROR: 30 no network service Check for registration (see par.
2.5.3.1) and signal strength.
+CME ERROR: 16 wrong network password check network password and
retry
For example:
1- Let's assume you want to bar all the outgoing calls (originated by mobile) and the network password
of your operator is 0000:
command:
AT+CLCK=AO,1,0000
response:
OK
3.2.4.5 Barring/Unbarring All Outgoing International Calls
•
Send command AT+CLCK=OI,,
where:
is the operation selected:
0 – Call Barring Disable (Unbarring)
1 – Call Barring Enable (Barring)
is the network password required to change facility status
•
wait for response:
Response Reason Action
OK Barring is now enabled/disabled all outgoing international calls
will be barred/unbarred
ERROR some error occurred Enable the extended error
codes report (see par.2.5.2.1)
and retry.
+CME ERROR: 4 operation not supported, the
service required is not available Check command syntax