Rainbow Electronics GE863-GPS low power - Manual (Page 26)

GE863-GPS Software User Guide
1vv0300724 Rev. 3 - 05/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 26 of 122
1 - microphone muted
NOTE: The mute setting is different from Volume setting: it refers to both the audio paths, the
mute setting will remain even when changing audio path.
2.6.2 Phone number dialing
2.6.2.1 Dial a given phone number
•
Send command ATD
where:
is the phone number to be dialed
•
wait for response:
Response Reason Action
OK The call has been placed Wait for the other party to lift
the receiver..
BUSY The line called is busy retry later
NO ANSWER The receiver did not answer the
call retry later
NO CARRIER Call placing has not been
successful check for mobile registration
and signal strength
For example:
1- Let's assume you have to call the national number 040 - 4192111,
command:
ATD 0404192111
response
OK
2- Let's assume you have to call the national number but in international format +39-40-4192111,
command:
ATD +39404192111
response
OK
3- Let's assume you have to call the international number +386-40-4192111 without previously setting
the +FCLASS=8 (voice),
command:
ATD +386404192111;
response
OK