RocketFish RF-TVMP40 - User Manual - Manual (Page 2)

2 Need help? Call 800-620-2790
RF-TVMP40 TV Wall Mount
Safety information and specifications
IMPORTANT SAFETY INSTRUCTIONS -
SAVE THESE INSTRUCTIONS
CAUTION: Do not use this product for
any purpose not explicitly specified by
Rocketfish.
Improper installation may cause
property damage or personal injury. If
you do not understand these directions, or have doubts
about the safety of the installation, contact Customer
Service or call a qualified contractor. Rocketfish is not
responsible for damage or injury caused by incorrect
installation or use.
The included hardware is designed for use on vertical walls
constructed of wood studs or solid concrete. A wood stud
wall is defined as consisting of a minimum of 2x4 wooden
studs (2” wide by 4” deep) with a maximum of 5/8”
drywall. The included hardware is not designed for use with metal studs or cinderblock walls. If you’re uncertain
about the construction of your wall, then please consult a qualified contractor or installer for assistance. For a
safe installation, the wall you are mounting to must support 4 times the weight of the total load. If not, then the
surface must be reinforced to meet this standard. The installer is responsible for verifying that the wall structure
and hardware used in any installation method will safely support the total load.
The weight of your TV must not exceed 40 lbs. (18.1 kg). Rocketfish recommends that the wall be capable of
supporting five times the weight of your TV and wall mount combined, or approximately 200 lbs (90.7 kg).
This product contains small items that could be a choking hazard if swallowed. Keep these items away from
young children!
Tools needed
You will need the following tools to assemble your new TV wall mount:
Maximum TV weight: 40 lbs. (18.1 kg)
Minimum TV weight: 18 lbs. (8.2 kg)
Maximum TV Screen size: 55 in. diagonal
Overall dimensions (W × H ):
3.5 x 8.9 in. (9.0 x 22.5 cm)
Wall-mount weight: 18 lbs. (8.2 kg)
We’re here for you
www.rocketfishproducts.com
For customer service, call:
800-620-2790 (U.S./Canada markets)
Edge-to-edge
stud finder
Pencil
Level
Phillips screwdriver
Socket wrench with 1/2"
(13 mm) socket.
&
1/4” drive socket wrench
for 8 mm socket (provided)
Measuring tape
Drill
7/32" (5.5 mm) wood drill
bit for wood stud wall
OR
3/8" (9.5 mm) masonry
drill bit (concrete only)
Hammer
Tape
RF-TVMP40_13-0238_MAN_V1_ENG.fm Page 2 Monday, April 15, 2013 1:26 PM