RocketFish RF-WFD301 - Quick Setup Guide - Manual

Your Rocketfish Miracast Video Receiver allows you to wirelessly stream content, like
movies, photos, music, and more from Miracast mobile devices, such as your
Android smart phone or tablet to your TV or projection screen.
Package contents
• Rocketfish Miracast Video Receiver
• 6" HDMI adapter
• 30" Micro USB charger cable
• Quick Setup Guide
System requirements
• Digital TV with an HDMI jack and a USB port
• A Miracast enabled mobile device with Android Jellybean 4.2.1 or newer
Features
Installing your receiver
1 Turn off the TV.
2 Insert the Rocketfish Miracast Video Receiver into the HDMI port on your TV. If the
video receiver will not fit into the HDMI port on your TV (too large or too wide), use
the 6" HDMI adapter for a better fit.
3 Insert the micro USB connector on the USB cable into the micro USB port on the
receiver. Insert the other end into the USB port on your TV. If the TV does not have a
USB port, use a powered USB hub (not included).
4 Turn on your TV, then press the TV’s Input or Source button to select the HDMI input
that the Rocketfish Wireless Video Receiver is connected to.
5 The LED on the Rocketfish Miracast Video Receiver starts to blink and the boot up
splash screen is displayed within 30 seconds. If the LED doesn’t blink or the boot up
splash screen is not seen, check to make sure that the TV input you have selected is
correct and the Rocketfish Wireless Video Receiver has power and is firmly connected
to the TV.
Setting up your receiver connection
When used for the first time, the Rocketfish Miracast Video Receiver starts in Auto mode
and is ready to accept a Wi-Fi direct connection.
1 Make sure that the TV or projection screen shows the Rocketfish Wireless Video
Receiver screen.
2 On your Miracast mobile device, such as a smartphone or tablet, turn on the Wi-Fi
network.
3 Press the WPS button on the Rocketfish Miracast Video Receiver. The blue LED will
start to blink while the receiver searches for a connection.
4 On your Miracast mobile device, select the SSID (network name) that is displayed on
your TV. See the documentation that came with your Miracast mobile device to
complete the setup.
5 When the connection is successful, your Miracast mobile device’s screen is displayed
on your TV, indicating that video streaming has started.
Before using your new product, please read these instructions to prevent any damage.
Receiver
USB jack
6" HDMI adapter
30" Micro
USB cable
QUICK SETUP GUIDE
Rocketfish Advanced Miracast Video Receiver
RF-WFD301
Need additional help?
See your User Guide! This comprehensive guide includes
everything from basic how-to steps to more advanced features.
Go to www.rocketfishproducts.com, then click Support &
Service. Enter your model number in the Manual, Firmware,
Drivers & Product Information, then click Search.
WPS button
Reset button