Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1895 - Manual (Page 9)

3. Electrical Installation
PNEG-1895 V2 Electronic Distributor Control 9
Control Panel Cable to Distributor Fitting Connections
Conduit for motor wiring should be run out of enclosure (DEC0005) (A) to the panel installed at ground
level. Conduit for sensor wiring should be run from enclosure (DEC0005) (A) to panel installed at ground
level. Appropriate fittings for conduit selection must be used at all connections.
(See Figure 3B.)
Figure 3B Cable Fitting Connections to Distributor Enclosure
Ref # Part# Description
A DEC0005 Enclosure
B DEC0026-XXX Sensor Cable
B DEC0025-XXX VFD Cable
NOTE: “XXX” represents the length of the cable.
A
B B