Grain Systems PNEG-1745 - Manual (Page 9)

PNEG-1745 WatchDog 9
3. Installation
Internet Connection (Part #: VIS-WATCH-IC)
This option requires an active internet connection be present at the dryer via Ethernet (RJ-45 connection).
It is recommended that either an Internet Service Provider (ISP) technician or someone versed in
networking be present during installation. While GSI’s Technical Support group can offer suggestions,
GSI is not responsible for the required connection.
Package Contents
The contents of this package are pictured in Figure 3A . Please refer to Figure 3A during installation.
Package contains:
1. Mounting plate with WatchDog circuit board attached.
2. WatchDog power cable.
3. Two (2) 1/4" mounting nuts. (Not Shown)
4. DB9 to 3 position quick connect cable (Serial Cable #1).
5. 3" DIN rail.
6. Two (2) self-tapping 1/4" screws.
7. Ten (10) cable ties for routing wires. (Not Shown)
8. Four (4) cable tie anchors for routing wires. (Not Shown)
Figure 3A
4
5
6
1
2