Grain Systems PNEG-1745 - Manual (Page 27)

3. Installation
PNEG-1745 WatchDog 27
6. The short-haul modem power supply should be plugged into a 120 VAC receptacle and the barrel
connector into the short-haul modem. The red power light should come ON.
7. Plug the power cable from the WatchDog enclosure into a 120 VAC receptacle.
Accessing the WatchDog
The WatchDog is accessed from the PC that the WatchDog enclosure is attached to. This PC will be used
in the section to connect to the dryer.
1. Make sure that the dryer is powered up and the Vision application is running. Also, verify the
WatchDog enclosure and both short-haul modems are plugged in.
2. On the PC, open up a web browser, i.e. Internet Explorer, Mozilla Firefox.
3. In the URL bar, enter “10.0.0.1” without the double quotes. There is no need put “www”, simply enter
the number sequence.
4. The “Login Screen” should now appear. If it does not, run back through the install procedure to verify
everything is connected properly.
Figure 3Z
5. Once the “Login Screen” appears, move on to Chapter 4 “WatchDog Operation” on Page 28 .