Grain Systems PNEG-1708 - Manual (Page 49)

9. Burner/Blower Module - Special Considerations
PNEG-1708 GSI Modular Tower Dryer 49
NOTE: The plank nearest the thermistor housing will need to be cut to allow it to drop into place.
This should be factory installed.
In Figure 9C , the installer is marking the plank so that it can be field cut for proper fit.
Figure 9D shows the marks where the plank needs to be cut for proper fit.
Note the tabs and slots on burner/blower floor planks. This helps differentiate them from catwalk planks.
(See Figure 9C.)
Figure 9C
Figure 9D
Tabs and slots
Thermistor conduit