Grain Systems PNEG-1708 - Manual (Page 42)

8. Assembling Ladders, Platforms and Catwalks
42 PNEG-1708 GSI Modular Tower Dryer
8. Attach catwalk brace to dryer wall using the previously installed catwalk brackets. Catwalk brace
attach to outside of bracket. (See Figure 8U.) Tighten fully with impact.
Lower arm of catwalk brace connects to top hole of bracket and upper catwalk brace arm connects
to top hole of bracket.
(See Figure 8U.)
In Figure 8U , the catwalk brackets all face . The catwalk brace attach to the outside of the
bracket and the catwalk brace all face .
9. Make sure, all catwalk brace should face the same direction.
Figure 8U
10. Make sure brackets and/or catwalk brace are NOT installed over the ladder braces as this would
block ladder installation. (See Figure 8V.)
Figure 8V
NOTE: All catwalk brackets and all catwalk brace should face the same direction.
Catwalk bracket
Catwalk brace
Gap to leave open for
ladder access.
Ladder brackets