Grain Systems PNEG-1708 - Manual (Page 41)

8. Assembling Ladders, Platforms and Catwalks
PNEG-1708 GSI Modular Tower Dryer 41
6. Attach catwalk brackets as shown in Figure 8R .
NOTE: All brackets must attach facing/angling the same direction. In the example on the right, all
brackets will face to match the bracket being installed.
Figure 8R Attaching catwalk bracket to dryer module.
7. Assemble catwalk brace/support braces by connecting as shown in Figure 8S and Figure 8T using
one nut and one bolt.
IMPORTANT: Finger-tighten only at this time so that the pieces act like a hinge. Place nut to the
inside as shown in Figure 8S and Figure 8T . This helps prevent snagging.
Figure 8S
Figure 8T
Catwalk bracket
Support braces
Catwalk brace
Cut-off angle
Support braces
Nut to inside