Rough Country 907S - Manual (Page 9)

SHIFT CONTROL BRACKET INSTALLATION
This step is performed only when transfer case drop is used. It is not required if drive shaft/SYE combination is being
installed.
1. From underneath the vehicle, locate the shift control bracket. It is attached to the inside of the transmission tunnel
on the driver side and acts as a pivot for the transfer case shift lever.
2. Remove the shifter linkage from the shifter plate that is mounted on the body tunnel as shown using a 10 mm
wrench. See Photo 1.
3. Reinstall the stock shifter bracket on the new drop bracket as shown with the 1/4” x 3/4” hardware. Tighten using
a 7/16” wrench. See Photo 2.
4. Install the supplied drop bracket on the stock tunnel bracket with the supplied 1/4” x 3/4” bolts/washers & nuts.
Tighten hardware using a 7/16” wrench. Check clearance on bolts. See Photo 3 & 4. In Photo 3, bracket is
shown removed to show mouting location. It is not necessary to remove the bracket although it can be removed
to ease installation.
Due to factory variations on the shifter rod bracket, it may be necessary to modify the shifter bracket by
slightly bending the mount on the rod to clear the shifter bracket or shifter bracket bolts. After noting how
much to bend the bracket to clear, remove the shifter assembly and bend the bracket as shown to slightly
clear the bracket / bolts. Do not over-bend!! See Photo 13.
Before After
PHOTO 13
PHOTO 2 PHOTO 1
INSTALL ASSEMBLY ON MOUNT SHIFTER ASSEMBLY SHOWN
PHOTO 3 PHOTO 4
BRACKET SHOWN INSTALLED ON MOUNT ASSEMBLY SHOWN INSTALLED IN MOUNT