Rough Country 907S - Manual (Page 10)

FLOOR PAN MODIFICATION ( MANUAL TRANS ONLY)
This step is only necessary if the vehicle exhibits problems shifting after the lift installation is complete. Test drive the
vehicle and shift through all gears. If it is difficult to shift into ( or the transmission jumps out of) Second , Fourth, or
Reverse, the shifter may be contacting the edge of the transmission tunnel due to the transfer case drop and might
need to be modified slightly. Examine the area and if the shifter is contacting in this area, proceed to the steps below.
If the boot is causing the bind the console can also be relocated or shifted approx 1” and remounted to allow the full
shift pattern to be obtained. Only trim if necessary on the tunnel cover.
1. Move the seats to full rearward position.
2. Pry up the shift boot and bezel from the floor console.
3. Remove the bolts attaching the console to the floor pan and lift
the console upward and remove.
4. Remove the 4 screws attaching the cover boot to the cover and
slide the boot upward to expose the opening in the floor pan.
5. Shift the transmission into 2nd and reverse verifying a minimum
of 1/8” clearance between the shifter lever and the floor pan. If
necessary, enlarge the opening in the floor pan with a round file
See PHOTO 1.
6. Reposition the boot clock wise to match the increased floor pan
opening. Mark and drill three new mounting holes. Reinstall the
cover boot, console, and shift boot.
7. Reinstall the cover boot, console, and shift boot.
PHOTO 1
TRIM AS NEEDED