Rough Country 907S - Manual (Page 8)

TRANSFER CASE DROP BRACKET INSTRUCTIONS
1. Place the transmission in neutral, chock wheels, and place floor jack under the transmission mount skid plate.
2. Using a floor jack, support the skid plate.
3. Slightly loosen the bolts on the transfer case skid plate on both sides to allow for some movement. Do not re-
move the bolts. See Photo 1.
4. Proceed to other side. NOTE: Do not attempt to take out the bolts on both sides simultaneously. Installation is
done one side at a time. Remove the three bolts holding the transfer case skid plate to the frame rail.
5. Using the floor jack, slightly lower the skid plate and insert the transfer case lowering spacer as shown in Photo
2. (Note the shorter of the two brackets will be installed on the passenger side on the 97-02 models)
6. Using the bolts supplied with the kit slightly tighten the bolts. Do not fully tighten to allow for some movement for
the opposite side.
7. Proceed to the opposite side of the vehicle and install the brackets as instructed above. After installing both
sides, tighten bolts.
Note: If your vehicle is equipped with a 4 speed automatic and is a 2003-2006 you will have an additional cross
member connected to the transfer case by a plate. On this vehicle a total of 2 spacers are used per side. In situa-
tions where you are using this vehicle with the front sway bars disconnected (and during full droop during installation)
the front drive shaft may hit this cross member.
PHOTO 1 PHOTO 2
REMOVE STOCK HARDWARE INSTALL T-CASE SPACERS