Atdec Telehook TH-VWV Installation manual - Manual (Page 4)

Step 6. Cabling
Step 7. Security (optional)
Step 8. Screen Removal
Installation complete!
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 16.09.13 ©
6.1. - Cabling sequence
Tilt up each row,
starting at the top,
leaving each screen
out until all cabling is
finished.
You may start from the
left or right.
Holes shown in the bracket and
wall plate can accommodate
security cabling and locks.
Wall Plate
To remove screen X for repair or replacement, tilt up the numbered screens in sequence, then pull out and lift off screen X.
6.2. To gain access for cabling:
Pull out the bottom
of the screen Push out the stop
found on each
bracket Push up the stop
and gently lower the
screen onto the wall.
1 2
3
x
1 2
3
x
2
1
x
Locks &
cabling not
supplied