Atdec Telehook TH-VWV Installation manual - Manual (Page 2)

Determine the desired height
of your screen from the floor.
Position your wall plate,
aligning the Contact Edge to
your mark.
Combine both heights to find
the height of the Contact
Edge of the Wall Plate &
mark this on the wall.
Contact Edge with the Hook
Measure the height between
the top of the hook to the
bottom of the screen.
Step 3. Mounting first Wall Plate
Masonry Timber Stud
Coach Screw Coach Screw
Washer
Washer
Ø10mm x 60mm deep
Drilled Hole Ø8mm x 60mm deep
Drilled Hole Nylon Anchor
2 coach screws are provided for the TH-VWP-100 and 3 coach screws are provided for the TH-VWP-160.
Ensure all screws are used with exception of where timber studs are spaced too far apart.
3.1. 3.2.
3.3.
Step A
Step B
3.4.
IMPORTANT! Any structural elements must be capable of supporting the combined weight of
all the equipment and devices being mounted. If in doubt, consult a structural engineer.
TIP: Use Mount as a drilling template.
Please use a Spirit Level during installation to
ensure that the Wall Plate is LEVEL
X
X
Y
Y
X Z Y = +