VEGA VEGATOR 632 - Manual (Page 40)

If you are using a probe without line break monitoring, a fault signal will
be triggered. In this case, set the switch (7) to off.
Only failures of channel 1 are monitored.
A failure is signalled via the red control lamp on the front plate.
Alarm
off on
1
2
3
4
5
6
7
Fig. 129: Switch block (A) with switch (7) for activation of the line break
monitoring (alarm)
You find detailed information on how to trigger a fault signal via the
second relay output in the previous chapter "Adjust relay function".
9 .5 Master/Slave function
Adjust the instrument as Master with switch 8 of the DIL switch block
(A). Definition of the instru-
ment as Master or Slave
(DIL switch block A)
40 VEGATOR 632 • Signal conditioning instrument
9 Set up - Two-channel control
35243
-EN
-120228