VEGA VEGATOR 632 - Manual (Page 29)

8 Set up - Two-point control Δs (pump
control)
8 .1 Adjust relay function
3-step switch. The individual switch positions are assigned as follows:
1
2
3
4
5
6
7
8
O N
3
1
3362
CH1 output parallel
CH2 output separate
CH1 with alarm
Fig. 58: Slide switch for adjustment of the relay outputs (D)
l CH 1 output parallel - Both relay outputs switch in parallel
l CH 2 output separate - Relay outputs switch separately
l CH 1 with alarm - Fault signal with relay output 2
The following charts provide an overview of the relay switching
conditions and the control lamps depending on the adjusted mode and
level.
Output relay 2 operates like output relay 1. The function of the two
output relays is the same.
Switching condition of the two channels see "CH 2 output separate".
Two-point control (pump control) Δs - Overfill protection (max.)
Specifications:
l Overfill protection (max.) - DIL switch block (A) switch 5 and 6 to
off
l Channel 1 (relay 1) and channel 2 (relay 2) switch separately (the
respective mode is selectable for each relay)
l Two-point control (pump control) - DIL switch block (A) switch 4 to
on (Δs)
Mode Level Channel 1 Channel 2 Control lamps
Two-point
control -
max.
6 4 5 16 17 15
ye ye gn rd
Adjustment of the relay
outputs (slide switch D)
CH 1 output parallel
CH 2 output separate
VEGATOR 632 • Signal conditioning instrument 29
8 Set up - Two-point control Δs (pump control)
35243
-EN
-120228