VEGA VEGAMET 514 - Manual (Page 35)

VEGAMET 514 35
Settings in the "extended menu"
7.5 Configuration of outputs
Config
inputs Config
meas.
loop Config
outputs
Config
current
output
Current
1 to
TAG -
No. 1
Volt1
to
TAG -
No. 1
Config
Volt
output Config
relay
output Config
PC/
PLC
output Config
VEGA-
DIS
DIS 1
to
TAG -
No. 1
DIS 2
to
----
DIS 3
to
----
PC/PLC
meas.
values
PLC 1
to
TAG -
No. 1
PLC 2
to
----
PLC 3
to
----
PC/PLC
relay
status
off
PC/PLC
input
status
off
Confi-
gura-
tion
TAG -
No. 1
%
xx,x
Param.
TAG-
No. 1
Fail
safe
relay
Relay
Stan-
dard
Oper-
ating
relay
Rel. 1
to
TAG -
No. 1
Rel. 2
Stan-
dard
---- ----
----
----
----
PC/PLC output and DIS output:
The PC/PLC signal as well as the DIS signal
are transmitted via the DISBUS. The PC/PLC
output delivers output signals from
VEGAMET to an interface converter
VEGACOM 557. This interface converter
transfers the signals of VEGAMET via differ-
ent standard protocols to connected sys-
tems (DCS/PLC). In the menu items "PLC 1
to" up to "PLC C to…" the measurement loop
can be allocated or switched off.
In the menu items "PC/PLC relay status" and
"PC/PLC input status" it can be determined
that the relay mode and input status are
transmitted via the DISBUS.
Up to three external indicating elements
(VEGADIS 174) can be connected to
DISBUS. In the menu items "DIS 1 to…" up to
"DIS 3 to–" the measurement loop can be
allocated or switched off.
The current, volt and relay outputs are allo-
cated as factory setting to measurement loop
"TAG-No. 1". All outputs can be switched off
individually (----), i.e., they will no longer
access a measurement loop.
Input
unde-
fined
Input4
Rel. 2
to
TAG -
No. 1
----
Rel. 1
Stan-
dard
Hold
function
Reset of
alarm
function
Input
unde-
fined
Input4 Hold
function
Reset of
alarm
function