Test Products International 440 User Manual

Page 34

Press SETUP/MEM Key

PAGE

EDIT

SAVE

LOAD

EXIT

F1:

Page Up, Down; Select Memory Location
(0,1,2,3,4,5,6,7 Page)

F2:

New Edit (Range, Contrast, D Mode, Baud Rate, etc.)

F3:

Save the present setup status

F4:

Load and setup from selected Memory

EDIT Press

NEXT

EXIT

NEXT:

Menu selection

Mode level and function selection.

f) Adjusting REL% and COMP reference value is as follows

1. Enter the REL% key COMP mode by pushing PROG key
2. Push the REL% key(F2) to adjust REL% reference value

and then push EDIT key(F4).

3. Set the digit by right and left direction key and set the

figure by up to down direction key and then push the
EXIT key.

4. Enter the COMP mode by pushing F3 key and push the

EDIT key(F4).

5. Set the digit by right and left direction key and set the

figure by up and down direction key and then push the
EXIT key(HI,LO,setting).

6. Push the RGE key and SETUP/MEM key.
7. Save the adjusted value with page up key(F1) to memory

page.