Veris Industries HWS SERIES Install - Manual (Page 3)

VERIS INDUSTRIES
™
inStallation GUiDe HWS SerieS
Z204453-0D PAGE 3 ©2010 Veris Industries USA 800.354.8556 or 1.503.598.4564 / [email protected] 06101
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
menu hws calibration instructions
RH can be field calibrated by moving RUN/CAL jumper to CAL position. 1.
Relative humidity allows for calibration offset of ±9.9% RH – user discretion. 2.
O U T P U T
0 - 1 0 V
C A L R H
+ 0 . 0 %
4 5 . 5 % R H
S E T P O I N T
4 5 % R H
SETPOINT MODE
(Enter by any keypress)
CONFIG/CAL MODE
(Run/cal jumper)
NORMAL MODE
only for switch in volts position
press± to change; press* to select
press± to change; press* to select
(choices are 50-95º F or 32-122º F)
in Cal Mode