Veris Industries HWS SERIES Install - Manual (Page 2)

VERIS INDUSTRIES
™
inStallation GUiDe HWS SerieS
Z204453-0D PAGE 2 ©2010 Veris Industries USA 800.354.8556 or 1.503.598.4564 / [email protected] 06101
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
RH
YES
AMP VOLT
NO
RUN CAL
–
Minus Plus Enter
+
1. Remove the cover by pressing the tab at the top of the sensor while pulling
outward from the top of the cover.
5. Mount the backplate onto the wall using the screws provided.
6. Wire the backplate.
3. Punch out openings in the backplate.
7. Install and configure the sensor.
8. Install the cover and snap into place.
correct
incorrect
4. Position the sensor vertically on the wall, 4 1/2 feet above the floor.
WARNING: Output select must be
correct before applying power.
Five screwholes available; use a mini-
mum of two for secure mounting.
2. Remove the backplate by unfastening the sensor from the bottom of the backplate
and pivoting the sensor outward.
installation
Output (3-Wire, 0-10V, 4-20mA)
POWER SUPPLY
24 VAC/DC
CONTROL SYSTEM
COMMON
RH INPUT
RH SETPOINT
PWR COMMON RH OUT RH SETPOINT
RH
SENSOR
TEMP
SENSOR
RH
YES
AMP VOLT
NO
RUN CA
L
–
Minus Plus Enter
+
RUN/CAL JUMPER:
CAL Mode - allows full access to all
features.
RUN Mode - allows access to
setpoint ONLY.
RH YES/NO JUMPER:
YES - allows user to change setpoint
(in humidistat mode)
NO - user can NOT change setpoint
(in humidistat mode)