Installation guide, Installation and wiring – Veris Industries MSBPA1x Install User Manual

Page 2

ZL0031-0B

PAGE 2

02121

Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.

MSBPA1x

INSTALLATION GUIDE

INSTALLATION AND WIRING

1. Turn off power at the circuit breaker. Use a properly rated voltage sensing device to

confirm power is off.

2. Remove existing wall switch, if applicable.

3. Wire the sensor according to the applicable wiring diagram below.

Single Level

LOAD

Neutral (WHT)

Ground (GRN)

Hot (BLK)

(RED)

Bi-Level

(RED)

LOAD

Neutral (WHT)

Ground (GRN)

Hot (BLK)

4. Mount sensor in electrical box and secure with two captive screws. Ensure that

sensor has an unobstructed view of the entire coverage area.

5. Attach wall plate (included) with two screws provided.

6. Turn on power at the circuit breaker.

7. Place the sensor in Auto mode by pushing Auto/Off button so that it latches in the

inward position (in = Auto mode, out = always off). In Auto mode, when motion

is detected, the red LED at the top of the sensor flashes on for approximately 0.5

seconds, and the lights turn on or remain on.

Note: When first installed, the sensor may have to warm up for a few minutes
before it is fully operational.

8. Vacate the room until the lights turn off.

9. Re-enter the room. Lights should turn on immediately. If not, check the wiring and

ground connection and toggle the Auto/Off button.

Adjustment:

1. Remove the adjustment access cover (located between the sensor lens and Auto/

Off button) by gently prying it off with a small, flathead screwdriver.

Adjustment
Dial

Bypass button
(In = Always ON,
Out = Normal
Operation)

2. Time Delay: The Time Delay determines how long the lights will stay on when

motion is no longer detected. Turn the adjustment dial to the desired setting:

from 15 sec. (fully counter-clockwise) to 30 min. (fully clockwise).

3. Disable: To disable the sensor, push the Auto/Off button so it latches in the

outward (always off) position. The lights will not come on.

4. Bypass: A latching bypass button is provided on the wall plate. In = Always On,

Out = Normal Operation.

5. Masking (optional): To reduce unwanted motion sensing, such as people moving

in adjacent areas, partially mask the sensor lens with opaque adhesive tape (not

included).

6. Replace the adjustment access cover by gently snapping it in place.