Installation, Installation guide temperature t series – Veris Industries T SERIES Install User Manual
Page 6
Z203672-0C
Page 6 of 7
©2013 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 09131
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
Installation Guide
Temperature
T Series
TM
Installation
TC/TS
1. Locate the electrical wiring in the area to be monitored. Press fit the TC/TS housing into the ceiling near this wiring.
2. Drill a mounting hole using a 1 3/8” hole saw (1” conduit, electrical trade).
3. Pull wires through the junction box or receptacle and connect them to the TC or TS device.
TRA
1. Set the stainless steel sensing probe in contact with the area to be monitored. No mounting is necessary.
2. Wire the sensor to the controller.
TW
1. Mount the housing vertically on an interior wall in the area to be monitored, in a location where air circulates freely. Locate unit
away from air outlets, corners, exterior walls, windows, and doors.
2. Wire the sensor to the controller.
TO
1. Locate a sheltered outdoor area out of direct sunlight (e.g. under eaves, north side of the building, etc.).
2. Wire the sensor to the controller.
3. The sensor may be suspended from the conduit without damage to the unit. Do not obstruct vent openings.
TIx
1. Thread the assembly into a pipe fitting.
2. Wire the sensor to the controller.
TD
1. Drill a 3/8” diameter hole for the sensor probe.
2. Insert the probe into the duct.
3. Secure the mounting flange to the outer surface of the duct using self-tapping screws provided.
4. Wire the sensor to the controller.
TA
1. Drill a 1 3/16” diameter hole in the duct for the sensor probe and lug.
2. Affix foam gasket material to the probe side of the junction box.
3. Insert the probe into the duct.
4. Secure the junction box housing to the outer surface of the duct using self-tapping screws (not included).
5. Wire the sensor to the controller.
TB
1. Clamp the sensor around the pipe to be monitored. Make sure the copper sensing plate is in contact with the pipe surface.
2. Wire the sensor to the controller.