Veris Industries 1010 Manual - Manual (Page 8)

6. Data Logging
To activate data logging press and hold down the key until the logging setup
screen is displayed. Once the logging function is activated all preciously logged
data is written over.
1) INT is displayed at the top to indicate the 1010 is waiting for the logging interval
to be set. The logging interval tells the 1010 how often to sample. For example, a
logging interval of 10 seconds (00:10) means the 1010 will log a reading every
10 seconds. The bottom indicates the current logging interval in minutes and sec-
onds (MM:SS) or hours and minutes (HH:MM). Flashing “SEC” in the display
indicates the last two digits are seconds and a flashing “MIN” in the display indi-
cates the last two digits are minutes. In seconds mode the time is adjustable from
1 sec to 59 min 59 sec. In the minutes mode the time is adjustable from 1 min to
2) Once the time mode is set press the
keys select the digit and the keys increase or decrease the value.
key and time digits will flash. Using
the Arrow keys set the interval to the desired level. The
3) Once the seconds have been entered, press the key to move to min / hr.
5) Once the logging interval is set press the
keys select the digit and the keys increase or decrease the value.
key and the 1010 will return to
the main display and “LOG” will flash indicating the logging function is active.
4) Using the Arrow keys set the interval to the desired level. The
6) To deactivate data logging press and hold down the key until “LOG” is
no longer flashing.
For data retrieval please see the next section on how to retrieve logged data.
23 hr 59 min. Pressing the keys switches between the two time
modes.
7. Retrieving Logged Data
To retrieve logged data the USB cable and PC software (both supplied) must be
used.
Install the PC software on your PC and open it.
Connect the 1010 to the PC using the USB cable.
Click on the connect to PC button in the software window.
The software can be used to retrieve logged data and for real time monitoring.
COM port setting is:
Baud rate: 19200
Parity: None
Data Bits: 8
Stop Bit: 1